Diagnosis Procedure

WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.

CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the following terminals and connectors for damage, bend and loose connection (connector side and harness side).
  - Harness connector E35
  - Harness connector B41
  - Harness connector B54
  - Harness connector B201
Is the inspection result normal?

YES

GO TO STEP 2 .

NO

Repair the terminal and connector.

CHECK HARNESS CONTINUITY (OPEN CIRCUIT)

Disconnect the following harness connectors.
- ABS Actuator And Electric Unit (Control Unit)
- Harness connector E35 and B41

Check the continuity between the ABS Actuator And Electric Unit (Control Unit) harness connector and the harness connector.

ABS Actuator And Electric Unit (Control Unit) harness connector		Harness connector		Continuity
Connector No.	Terminal No.	Connector No.	Terminal No.
E125	41	E35	8	Existed
	27		7	Existed

Is the inspection result normal?

YES

GO TO STEP 3 .

Repair the main line between the ABS Actuator And Electric Unit (Control Unit) and the harness connector E35.

CHECK HARNESS CONTINUITY (OPEN CIRCUIT)

Disconnect the harness connectors B54 and B201.

Check the continuity between the harness connectors.

Harness connector		Harness connector		Continuity
Connector No.	Terminal No.	Connector No.	Terminal No.
B41	8	B54	5	Existed
	7		4	Existed

Is the inspection result normal?

YES

Check CAN system type decision again.

YES

Error was detected in the main line between the ABS Actuator And Electric Unit (Control Unit) and the driver seat control unit.

Repair the main line between the harness connector B41 and driver seat control unit.