Diagnosis Procedure

WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.

CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors of the combination meter for damage, bend and loose connection (unit side and connector side).
Is the inspection result normal?

YES

GO TO STEP 2 .

NO

Repair the terminal and connector.

CHECK HARNESS FOR OPEN CIRCUIT

Disconnect the connector of combination meter.

Check the resistance between the combination meter harness connector terminals.

With type A

Combination meter harness connector			Resistance (Ω)
Connector No.	Terminal No.
M25	46	45	Approx. 54 - 66

With type B

Combination meter harness connector			Resistance (Ω)
Connector No.	Terminal No.
M163	34	35	Approx. 54 - 66

NOTE: Check the combination meter type to confirm the service information. Refer to Information .

Is the measurement value within the specification?

YES

GO TO STEP 3 .

Repair the combination meter branch line.

CHECK POWER SUPPLY AND GROUND CIRCUIT
Check the power supply and the ground circuit of the combination meter. Refer to the following.
- TYPE A: Diagnosis Procedure
- TYPE B: Diagnosis Procedure
Is the inspection result normal?

YES

Replace the combination meter. Refer to the following.
- TYPE A: Removal and Installation
- TYPE B: Removal and Installation
YES

Error was detected in the combination meter branch line.

NO

Repair the power supply and the ground circuit.