DTC Confirmation Procedure
WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
- PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
GO TO STEP 2 .
- DTC REPRODUCTION PROCEDURE
CONSULT
- Drive at 30 km/h (19 MPH) or more for approximately 1 minute.
- Select "Self Diagnostic Result" mode of "DIFF LOCK".
Is DTC "P18D0" detected?
YES
Proceed to diagnosis procedure. Refer to Diagnosis Procedure .
NO
To check malfunction symptom before repair: Refer to Intermittent Incident .
NO
Confirmation after repair: Inspection End.