Data Monitor
|
Monitor item (Unit) |
Remarks |
|
4L SWITCH (On/Off) |
4WD shift switch signal (4LO) is displayed. |
|
4H SWITCH (On/Off) |
4WD shift switch signal (4H) is displayed. |
|
2WD SWITCH (On/Off) |
4WD shift switch signal (2WD) is displayed. |
|
4WD MODE (BOTNG/SWTNG/2WD/4L/LOCK) |
Control status of 4WD mode is displayed. (LOCK means 4H of 4WD mode) |
|
IGN SW (On/Off) |
Ignition switch status is displayed. |
|
BRAKE SWITCH (On/Off) |
Stop lamp switch signal status via CAN communication line is displayed. |
|
SLCT LVR POSI (D/N/R/P) |
A/T shift selector position via CAN communication line is displayed. |
|
MODE SENSOR (On/Off) |
Mode sensor status is displayed. |
|
RANGE SENSOR 2 (On/Off) |
Range sensor status is displayed. |
|
RANGE SENSOR 1 (On/Off) |
Range sensor status is displayed. |
|
4WD MODE IND (2WD/LOCK/4L) |
Control status of 4WD mode indicator lamp is displayed. (LOCK means 4H of 4WD mode) |
|
4WD FAIL LAMP (On/Off) |
Control status of 4WD warning lamp is displayed. |
|
ATP IND (On/Off) |
Control status of ATP warning lamp is displayed. |
|
MOTOR DRIVE A (Hi/Low/PWM) |
Driving status of transfer motor is displayed. (Drive side) |
|
MOTOR DRIVE B (Hi/Low/PWM) |
Driving status of transfer motor is displayed. (Reverse side) |
|
FLUID TEMP SE (V) |
This item is not equipped, but displayed. |
|
C/U POWER SUP (V) |
Power supply voltage value of transfer control unit is displayed. |
|
MOTOR POWER SUP (V) |
Power supply voltage value of transfer motor unit is displayed. |
|
ROTARY POSITION SENSOR (%) |
Transfer rotary position sensor signal is displayed. |
|
FRONT AXLE ACTR PWR RLY (On/Off) |
Axle disconnect device relay control signal status is displayed. (Models with axle disconnect device) |
|
FRONT AXLE SW (On/Off) |
Position detection switch of axle disconnect device actuator status is displayed. (Models with axle disconnect device) |
|
FRONT AXLE CONTROL (On/Off) |
Motor of axle disconnect device actuator control signal status is displayed. (Models with axle disconnect device) |
|
COMPR VHCL SPEED (km/h or mph) |
Vehicle speed calculated by transfer control unit is displayed. |
|
VHCL/S SEN-FR (km/h or mph) |
Wheel speed (front) average calculated by transfer control unit. |
|
VHCL/S SEN-RR (km/h or mph) |
Wheel speed (rear) average calculated by transfer control unit. |
|
ENGINE SPEED SIG (rpm) |
Engine status via CAN communication line is displayed. |