LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 173 (Transfer Case) >> Removal And Installation >> Rear Oil Seal >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain transfer fluid. Refer to Draining .
  2. Remove rear propeller shaft. Refer to Removal and Installation .
  3. Remove self-locking nut from rear companion flange using a suitable flange wrench.
    CAUTION: Do not reuse self-locking nut.
  4. Remove O-ring.
    CAUTION: Do not reuse O-ring.
  5. Put a matching mark on rear output shaft (B) in line with a mark on rear companion flange (A).
    GNSAWDIA1367Z-367Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION: Use paint to make matching mark on rear drive companion flange and rear output shaft. Do not damage rear output shaft.
  6. Remove companion flange using a suitable tool.
  7. Remove rear oil seal.
    CAUTION:
    • Do not damage rear case or rear output shaft.
    • Do not reuse rear oil seal.
scientia non olet · About LEMON Manuals