LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 170 (Front Axle) >> Removal And Installation >> Front Drive Shaft Boot >> Wheel Side >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove front drive shaft. Refer to Removal and Installation .
  2. Secure the front drive shaft in a vise.
    CAUTION: When securing shaft in a vise, always use copper or aluminum plates between vise and shaft.
  3. Remove boot bands and slide the boot back.
    CAUTION: Do not reuse boot bands.
  4. Using a suitable tool (A), pull joint sub-assembly off of shaft.
    GNSJPDIF0015Z-015Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION:
    • Align suitable tool (B) and drive shaft, then remove joint sub-assembly by pulling directly.
    • If joint sub-assembly cannot be removed after five or more unsuccessful attempts, replace the entire drive shaft.
  5. Remove boot from shaft.
    CAUTION: Do not reuse boot.
  6. Remove circular clip from shaft.
    CAUTION: Do not reuse circular clip.
  7. While rotating ball cage, clean the old grease off the joint sub-assembly.
scientia non olet · About LEMON Manuals