Diagnosis Procedure

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

CHECK DOOR MIRROR LH SENSOR SIGNAL

Turn ignition switch to ACC.

Check voltage between door mirror LH harness connector and ground.

(+)		(-)	Condition		Voltage (V) (Approx.)
Door mirror LH
Connector	Terminal
D12	24	Ground	Door mirror LH	Close to peak	3.4
				Close to valley	0.6
	23			Close to right edge	3.4
				Close to left edge	0.6

Is the inspection result normal?

YES

GO TO 5

GO TO 2

CHECK DOOR MIRROR LH SENSOR CIRCUIT 1

Turn ignition switch OFF.
Disconnect automatic drive positioner control unit and door mirror LH connector.

Check continuity between automatic drive positioner control unit harness connector and door mirror LH harness connector.

Automatic drive positioner control unit		Door mirror LH		Continuity
Connector	Terminal	Connector	Terminal
M63	6	D12	24	Yes
	18		23

Check continuity between automatic drive positioner control unit harness connector and ground.

Automatic drive positioner control unit		Ground	Continuity
Connector	Terminal
M63	6		No
	18

Is the inspection result normal?

YES

GO TO 3

Repair or replace harness.

CHECK DOOR MIRROR LH SENSOR CIRCUIT 2

Check continuity between automatic drive positioner control unit harness connector and door mirror LH harness connector.

Automatic drive positioner control unit		Door mirror LH		Continuity
Connector	Terminal	Connector	Terminal
M63	20	D12	21	Yes
	21		22

Check continuity between automatic drive positioner control unit harness connector and ground.

Automatic drive positioner control unit		Ground	Continuity
Connector	Terminal
M63	20		No
	21

Is the inspection result normal?

YES

GO TO 4

Repair or replace harness.

CHECK TILT MOTOR ADJUSTING OPERATION
1. Connect automatic drive positioner control unit and door mirror LH.
2. Turn ignition switch ON.
3. Check tilt motor adjusting operation with memory function.
Is the operation normal?

YES

Replace door mirror actuator (built into door mirror LH). Refer to Removal and Installation .

NO

Replace automatic drive positioner control unit. Refer to Removal and Installation .
CHECK INTERMITTENT INCIDENT
Refer to Intermittent Incident .

Is the inspection result normal?

YES

Replace automatic drive positioner control unit. Refer to Removal and Installation .

NO

Repair or replace the malfunctioning part.