Diagnosis Procedure

1. Turn ignition switch ON.
2. Check voltage between door mirror connector and ground.

   (+)		(-)	Door mirror remote control switch condition	Voltage (V) (Approx.)
   Door mirror
   Connector	Terminal
   D12 (LH) D114 (RH)	12	Ground	UP	Battery voltage
   			Other than above	0
   	11		LEFT	Battery voltage
   			Other than above	0
   	10		DOWN / RIGHT	Battery voltage
   			Other than above	0

Is the inspection result normal?

YES

Refer to Component Inspection .

NO

GO TO 2

1. Turn ignition switch OFF.
2. Disconnect automatic drive positioner control unit and door mirror.
3. Check continuity between automatic drive positioner control unit connector and door mirror connector.

   Door mirror LH

   Automatic drive positioner control unit		Door mirror LH		Continuity
   Connector	Terminal	Connector	Terminal
   M63	12	D12	10	Yes
   	23		12
   	24		11

   Door mirror RH

   Automatic drive positioner control unit		Door mirror RH		Continuity
   Connector	Terminal	Connector	Terminal
   M63	10	D114	12	Yes
   	11		11
   	22		10

4. Check continuity between automatic drive positioner control unit connector and ground.

   Door mirror LH

   Automatic drive positioner control unit		Ground	Continuity
   Connector	Terminal
   M63	12		No
   	23
   	24

   Door mirror RH

   Automatic drive positioner control unit		Ground	Continuity
   Connector	Terminal
   M63	10		No
   	11
   	22

Is the inspection result normal?

YES

GO TO 3

NO

Repair or replace harness.

1. Connect automatic drive positioner control unit.
2. Turn ignition switch ON.
3. Check voltage between automatic drive positioner control unit connector and ground.

   Door mirror LH

   (+)		(-)	Mirror switch condition	Voltage (V) (Approx.)
   Automatic drive positioner control unit
   Connector	Terminal
   M63	12	Ground	DOWN / RIGHT	Battery voltage
   			Other than above	0
   	23		UP	Battery voltage
   			Other than above	0
   	24		LEFT	Battery voltage
   			Other than above	0

   Door mirror RH

   (+)		(-)	Mirror switch condition	Voltage (V) (Approx.)
   Automatic drive positioner control unit
   Connector	Terminal
   M63	10	Ground	UP	Battery voltage
   			Other than above	0
   	11		LEFT	Battery voltage
   			Other than above	0
   	22		DOWN / RIGHT	Battery voltage
   			Other than above	0

Is the inspection result normal?

YES

GO TO 4.

NO

Replace automatic drive positioner control unit. Refer to Removal and Installation .

Check door mirror motor.

Refer to Component Inspection .

Is the inspection result normal?

YES

Refer to Intermittent Incident .

NO

Replace door mirror actuator. Refer to Removal and Installation .