Diagnosis Procedure

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
1. Turn ignition switch ON.
2. Check "Self Diagnostic Result" mode of "AUTO DRIVE POS".
3. Erase the DTC.
4. Perform DTC confirmation procedure. Refer to DTC Confirmation Procedure .
Is the DTC displayed again?

YES

Replace driver seat control unit. Refer to Removal and Installation .

NO

GO TO 2.
CHECK INTERMITTENT INCIDENT
Refer to Intermittent Incident .

Inspection End.