LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 169 (Brake System) >> Removal And Installation >> Rear Disc Brake >> Brake Caliper Assembly >> Removal and Installation >> Inspection After Installation

Inspection After Installation

WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check drag of rear disc brake. If any drag is found, follow procedure described below.
  2. Remove brake pads.
  3. Using a suitable tool, press the pistons into brake caliper body.
    CAUTION: Do not damage the piston boots.
  4. Install brake pads.
  5. Depress brake pedal several times.
  6. Check drag of rear disc brake again. If any drag is found, disassemble brake caliper body. Refer to Disassembly and Assembly .
  7. Burnish contact surfaces after refinishing or replacing disc brake rotors or if a soft pedal occurs at very low mileage. Refer to Brake Burnishing .
scientia non olet · About LEMON Manuals