LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 169 (Brake System) >> Removal And Installation >> Brake Piping >> Rear >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the wheels and tires using power tool. Refer to Removal and Installation .
  2. Loosen the flare nut with a flare nut wrench and separate the brake tubes and the brake hoses.
    CAUTION:
    • Do not scratch the flare nut and the brake tube.
    • Do not bend sharply, twist or strongly pull out the brake hose or brake tube.
    • Cover open end of brake hose or brake tube when disconnecting to prevent entrance of dirt.
  3. Remove the union bolt (A) and copper sealing washers (1), and remove the brake hose from the brake caliper assembly.
    GNSAWFIA0795Z-795Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION: Do not reuse copper sealing washers.
  4. Remove the lock plate and remove the brake hose.
scientia non olet · About LEMON Manuals