LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 169 (Brake System) >> Removal And Installation >> Brake Pedal >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the instrument lower panel LH. Refer to Removal and Installation .
  2. Disconnect the harness connectors from the stop lamp switch and brake pedal position switch (VK56VD) or ASCD cancel switch (Cummins 5.0L).
  3. Remove the stop lamp switch and the brake pedal position switch (VK56VD) or ASCD cancel switch (Cummins 5.0L).
  4. Remove the snap pin and clevis pin from the clevis of brake booster.
  5. Remove the brake pedal assembly nuts.
    CAUTION: Support the hydraulic booster assembly to prevent contact with other parts.
    NOTE: Remove brake pedal assembly top nut first.
  6. Remove the brake pedal assembly.
scientia non olet · About LEMON Manuals