Disc Brake Rotor: Inspection: RUNOUT
WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
- Check wheel bearing axial end play before inspection. Refer to Inspection .
- Secure disc brake rotor to wheel hub and bearing with wheel nuts at two wheel nut locations.
- For XD Models, measure runout using a dial indicator 20 mm (0.79 in) from disc brake rotor edge.
Runout
: Refer to Front Disc Brake .
- For Non-XD Models, measure runout using a dial indicator 10 mm (0.39 in) from disc brake rotor edge.
Runout
: Refer to Front Disc Brake .
- Find installation position with a minimum runout by shifting the disc brake rotor-to-wheel hub and bearing installation position by one hole at a time if runout exceeds limit value.
- Refinish disc brake rotor if runout is outside limit even after performing above operation. When refinishing, use Tool.
Tool number
: 38-PFM92 (-)
CAUTION:- Check in advance that the thickness of the disc brake rotor is wear thickness + 0.3 mm (0.012 in) or more.
- If the thickness is less than wear thickness + 0.3 mm (0.012 in), replace the disc brake rotor.
Wear thickness
: Refer to Front Disc Brake .