Shock Absorber: Disposal

WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.

Set shock absorber horizontally with the piston rod fully extended.
Drill a 2 - 3 mm (0.08 - 0.12 in) hole at the position ( ) from the top as shown to release gas gradually.

Courtesy of NISSAN NORTH AMERICA, INC.
CAUTION:
- Wear eye protection (safety glasses).
- Wear gloves.
- Be careful with metal chips or oil blown out by the compressed gas.
NOTE:
- Drill vertically in this direction ( ) directly into the outer tube avoiding brackets.
- The gas is clear, colorless, odorless, and harmless.
A

: 20 - 30 mm (0.79 - 1.18 in)
Position the drilled hole downward and drain oil by moving the piston rod several times.
CAUTION: Dispose of drained oil according to the law and local regulations.