LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 167 (Front Suspension) >> Removal And Installation >> Coil Spring And Shock Absorber >> Removal and Installation - 4WD >> Removal

Removal and Installation - 4WD: Removal

WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the wheel and tire using power tool. Refer to Removal and Installation .
  2. Support the lower link using a suitable jack.
    WARNING: Place a suitable jack under the lower link.
    CAUTION: Do not damage the lower link with the suitable jack.
  3. Separate the outer socket from the steering knuckle using the following steps:
    1. Remove the cotter pin (A) and loosen the nut (B) from the outer socket.
      GNSALGIA0285Z-285Courtesy of NISSAN NORTH AMERICA, INC.
      CAUTION: Do not reuse the cotter pin.
      NOTE: XD Models shown, Non-XD Models similar.
    2. Separate the outer socket from the steering knuckle using suitable tool.
      CAUTION: Leave the outer socket nut half threaded on the outer socket to prevent damage to the threads and to prevent the suitable tool from coming off suddenly.
    3. Remove the outer socket nut and separate the outer socket from the steering knuckle.
  4. Remove the front coil spring and shock absorber lower bolt.
  5. Remove the front coil spring and shock absorber upper nuts.
  6. Remove the front coil spring and shock absorber.
scientia non olet · About LEMON Manuals