LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 165 (Brake Control System (DTC/Circuit Diagnosis)) >> DTC/Circuit Diagnosis >> DTC C1144: Incomplete Steering Angle Sensor Adjustment >> Diagnosis Procedure

Diagnosis Procedure

WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
  1. Adjust The Neutral Position Of Steering Angle Sensor 

    Perform Neutral Position Adjustment Of Steering Angle Sensor. Refer To Description .

    GO TO STEP 2  .

  2. Check ABS Actuator And Electric Unit (Control Unit) 

    SYMBOL consult

    1. Turn The Ignition Switch Off.
      NOTE: Wait At Least 10 Seconds After Turning Ignition Switch Off.
    2. Start The Engine.
      NOTE: Wait At Least 10 Seconds After Start The Engine.
    3. Select "Self Diagnostic Result" Mode Of "ABS".

    Is DTC "C1144" Detected?

    Yes

    GO TO STEP 3  .

    No

    Inspection End.

  3. Check Steering Angle Sensor System 
    1. Turn The Ignition Switch Off.
    2. Check The Steering Angle Sensor System. Refer To Diagnosis Procedure .

    Is The Inspection Result Normal?

    Yes

    GO TO STEP 4  .

    No

    Repair / Replace Harness, Connector, Or Terminal.

  4. Check Data Monitor 

    SYMBOL consult

    1. Select "ABS", "Data Monitor" And "Str Angle Sig" In This Order.
    2. Check That The Indication Changes With The Steering Angle When The Steering Wheel Is Turned Left/Right From The Neutral Position. Refer To Values On The Diagnosis Tool .

    Is The Inspection Result Normal?

    Yes

    Replace The ABS Actuator And Electric Unit (Control Unit). Refer To Removal And Installation .

    No

    Replace The Steering Angle Sensor. Refer To Removal And Installation .

scientia non olet · About LEMON Manuals