LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 165 (Brake Control System (DTC/Circuit Diagnosis)) >> DTC/Circuit Diagnosis >> DTC C1118: Transfer Control Unit >> Diagnosis Procedure

Diagnosis Procedure

WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check 4WD System 

    SYMBOL Consult

    Perform "Self Diagnostic Result" Of "All Mode AWD/4WD".

    Is Any DTC Detected?

    Yes

    Check The DTC. Refer To DTC Index .

    No

    GO TO STEP 2  .

  2. Perform Self-Diagnosis 

    SYMBOL Consult.

    1. Erase "Self Diagnostic Result" Mode Of "ABS".
    2. Turn The Ignition Switch Off, And Wait 10 Seconds Or More.
    3. Start The Engine And Drive The Vehicle For A Short Period Of Time.
      NOTE: Vehicle Must Be Driven After Repair Or Replacement To Erase The Previous DTCs.
    4. Stop The Vehicle.
    5. Perform "Self Diagnostic Result" Of "ABS".

    Is DTC "C1118" Detected?

    Yes

    Replace The ABS Actuator And Electric Unit (Control Unit). Refer To Removal And Installation .

    No

    Check Pin Terminals And Connection Of Each Harness Connector For Abnormal Conditions. Repair / Replace Harness, Connector, Or Terminal.

scientia non olet · About LEMON Manuals