LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 164 (Maintenance (CUMMINS 5.0L)) >> Periodic Maintenance >> Chassis And Body Maintenance >> Transfer Fluid >> Refilling

Transfer Fluid: Refilling

WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove filler plug (1). Fill with new transfer fluid up to hole for the filler plug (A).
    GNSDB118186Courtesy of NISSAN NORTH AMERICA, INC.

    Recommended fluid and capacity

    : Refer to Cummins 5.0L Engine : Fluids and Lubricants 
    CAUTION: Carefully fill the fluid. (Fill for approximately 3 minutes.)
  2. Leave the vehicle for 3 minutes, and check the fluid level again.
  3. Apply sealant to thread of filler plug, and install it on transfer and tighten to the specified torque.
    CAUTION: Remove old sealant from thread of filler plug.

    Specified torque

    : 20.5 N.m (2.1 kg-m, 15 ft-lb)

    Sealant

    : Hylomar 102 silicone or equivalent
scientia non olet · About LEMON Manuals