LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 163 (Maintenance (5.6L)) >> Periodic Maintenance >> Chassis And Body Maintenance >> Rear Propeller Shaft >> Inspection >> Propeller Shaft Vibration

Propeller Shaft Vibration

WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: If vibration is present at high speed, check propeller shaft runout first, then check mounting between propeller shaft and companion flange.
  1. Measure the runout of the propeller shaft tube at several points by rotating the final drive companion flange with your hands.
    GNSDB115891Courtesy of NISSAN NORTH AMERICA, INC.

    Propeller shaft runout

    : Refer to General Specification .
    GNSDB113312Courtesy of NISSAN NORTH AMERICA, INC.
  2. If the runout still exceeds specifications, disconnect the propeller shaft at the final drive companion flange; then rotate the companion flange 90°, 180°, 270° and reconnect propeller shaft.
  3. Check the runout again. If the runout still exceeds specifications, replace the propeller shaft assembly.
  4. After installation, check for vibration by driving the vehicle.
scientia non olet · About LEMON Manuals