LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 163 (Maintenance (5.6L)) >> Periodic Maintenance >> Chassis And Body Maintenance >> Disc Brake >> Inspection - Rear Brake Rotor >> RUNOUT

Inspection - Rear Brake Rotor: RUNOUT

WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check wheel bearing axial end play before inspection. Refer to On-Vehicle Inspection .
  2. Secure disc brake rotor to wheel hub and bearing with wheel nuts at two wheel nut locations.
  3. Measure runout using a dial gauge 20 mm (0.79 in) from disc brake rotor edge.

    Runout

    : Refer to Rear Disc Brake .
  4. Find installation position with a minimum runout by shifting disc brake rotor-to-wheel hub and bearing installation position by one hole at a time if runout exceeds limit value.
  5. Refinish disc brake rotor if runout is outside limit even after performing above operation. When refinishing, use Tool.

    Tool number

    : 38-PFM92 (-)
    CAUTION:
    • Check in advance that the thickness of the disc brake rotor is wear thickness + 0.3 mm (0.012 in) or more.
    • If the thickness is less than wear thickness + 0.3 mm (0.012 in), replace the disc brake rotor.

    Wear thickness

    : Refer to Rear Disc Brake .
scientia non olet · About LEMON Manuals