LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 154 (Steering System) >> Removal And Installation >> Steering Gear And Linkage >> Removal and Installation - Inner socket >> Installation

Removal and Installation - Inner socket: Installation

WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place spacer on end of rack bar.
  2. Apply medium strength thread locker to threads of inner socket. Tighten inner socket to specified torque. Refer to Exploded View .
  3. Install boot. Refer to Removal and Installation - Boot .
  4. Check wheel alignment. Refer to Inspection .
  5. Adjust neutral position of steering angle sensor. Refer to Description .
scientia non olet · About LEMON Manuals