LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 154 (Steering System) >> Removal And Installation >> Power Steering Oil Pump >> Removal and Installation - VK56VD >> Removal

Removal and Installation - VK56VD: Removal

WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: When removing components such as hoses, tubes/lines, etc., cap or plug openings to prevent fluid from spilling.
  1. Drain power steering fluid from power steering reservior tank
    CAUTION: Do not reuse drained power steering fluid.
  2. Remove drive belt. Refer to Removal and Installation - Drive Belt .
  3. Disconnect harness connector (A) from power steering pressure switch (1).
    GNSALGIA0297Z-297Courtesy of NISSAN NORTH AMERICA, INC.
  4. For Non-XD models:
    1. Remove front wheel and tire (RH). Refer to Removal and Installation .
    2. Remove front fender protector (RH). Refer to Removal and Installation - Front Fender Protector .
    3. Complete remaining steps from wheelhouse.
      NOTE: For XD models, complete remaining steps from engine compartment.
  5. Disconnect power steering suction hose from power steering oil pump.
  6. Remove eye bolt and disconnect power steering pressure line from power steering oil pump. Plug lines and discard copper sealing washers.
    CAUTION: Do not reuse copper sealing washers.
  7. Remove bolts and power steering pump.
  8. Remove power steering pump mounting bracket from engine, if necessary. Refer to Removal and Installation: VK56VD .
scientia non olet · About LEMON Manuals