Removal and Installation: Installation
WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
Installation is in the reverse order of removal.
- Confirm mating marks are aligned with hose and clamp. Correct if needed.
- For Cummins 5.0, using new copper sealing washers (2), align power steering pressure hose (3) projection (A) with notch on power steering pump (1). Install eye bolt (B) and tighten by hand, then torque to specification. Refer to Exploded View .CAUTION: Do not reuse copper sealing washers.
- For VK56VD, using new copper sealing washers (2), align power steering pressures hose (3) projection (A) with notch on power steering pump (1). Install eye bolt (B) and tighten by hand, then torque to specification. Refer to Exploded View .CAUTION: Do not reuse copper sealing washers.
- Fill power steering fluid. Refer to Refilling and Air Bleeding Hydraulic System .CAUTION: Do not reuse drained power steering fluid.
- Bleed air from power steering system. Refer to Refilling and Air Bleeding Hydraulic System .
- Check for power steering fluid leaks. Refer to Fluid Leak Inspection .