LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 154 (Steering System) >> Removal And Installation >> Hole Cover Seal >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
  1. Set front wheels and tires in straight-ahead position.
    CAUTION: Secure steering wheel with string so that it will not be rotated out of position and damage spiral cable.
  2. Remove nut (A) and pinch bolt (B) from steering column joint.
    GNSAWGIA0423Z-423Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION: Do not reuse nut.
  3. Release collar lock tabs (A), then separate intermediate shaft (1) from steering column joint (2) in direction shown (SYMBOL ).
    GNSALGIA0269Z-269Courtesy of NISSAN NORTH AMERICA, INC.
  4. Remove collar (A) from intermediate shaft (1).
    GNSAWGIA0410Z-410Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION: If collar is damaged, collar must be replaced.
  5. Remove clamp (1) and hole cover seal (2) from hole cover.
    GNSAWGIA0424Z-424Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION: Do not damage hole cover seal during removal. If seal is damaged, it must be replaced.
scientia non olet · About LEMON Manuals