DTC Detection Logic
WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- If DTC B26F3 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to DTC Description .
- If DTC B26F3 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to DTC Description .
|
DTC No. |
CONSULT screen terms (Trouble diagnosis content) |
DTC Detection Condition |
|
|
B26F3 |
START CONT RLY ON |
Diagnosis condition |
When the ignition switch is ON. |
|
Signal (terminal) |
- |
||
|
Threshold |
BCM requests IPDM E/R to turn starter control relay OFF, but BCM cannot receive starter control relay OFF state signal from IPDM E/R (CAN) |
||
|
Diagnosis delay time |
- |
||