Diagnosis Procedure

1. Turn ignition switch ON.
2. Select "SFT P -MET", "SFT N -MET" and "SFT PN/N SW" in "Data Monitor" mode.
3. Check "SFT P -MET", "SFT N -MET" and "SFT PN/N SW" indication under the following conditions:

   Monitor item	Condition		Indication
   SFT P -MET	CVT Shift selector	Selector lever is in any position except the P (Park) position	OFF
   		Selector lever is in the P (Park) position	ON
   SFT N -MET	CVT Shift selector	Selector lever is in any position except the N (Neutral) position	OFF
   		Selector lever is in the N (Neutral) position	ON
   SFT PN/N SW	CVT Shift selector	Selector lever is in any position except the P (Park) or N (Neutral) position	OFF
   		Selector lever is in the P (Park) or N (Neutral) position	ON

Is the inspection result normal?

YES

Refer to Intermittent Incident .

NO

If "SFT N -MET" or "SFT P -MET" is incorrect. GO TO 7.

NO

If "SFT PN/N SW" is incorrect. GO TO 2.

CONSULT

Check DTC in "Self Diagnostic Result" mode of "TCM".

Is DTC detected?

YES

Perform the trouble diagnosis related to the detected DTC. Refer to DTC Index .

NO

GO TO 3.

1. Turn ignition switch ON.
2. Check voltage between BCM harness connector and ground.

   (+)		(-)	Condition		Voltage (V) (Approx.)
   BCM
   Connector	Terminal
   M21	39	Ground	Selector lever	P (Park) or N (Neutral) position	Battery voltage
   				Other than above	0

Is the inspection result normal?

YES

GO TO 4.

NO

GO TO 5.

1. Replace BCM. Refer to Removal and Installation .
2. Perform initialization of BCM and registration of all Intelligent Keys using CONSULT.

Inspection End.

1. Turn ignition switch OFF.
2. Disconnect transmission range switch connector.
3. Disconnect BCM connector.
4. Check continuity between transmission range switch harness connector and BCM harness connector.

   Transmission range switch		BCM		Continuity
   Connector	Terminal	Connector	Terminal
   F86	10	M21	39	Yes

5. Check continuity between transmission range switch harness connector and ground.

   Transmission range switch		Ground	Continuity
   Connector	Terminal
   F86	10		No

Is the inspection result normal?

YES

GO TO 6.

NO

Repair or replace harness.

Refer to Intermittent Incident .

Inspection End.

CONSULT

1. Turn ignition switch ON.
2. Select "SHIFT IND" in "Data Monitor" mode of "METER".
3. Check "SHIFT IND" indication under the following conditions:

   Monitor item	Condition		Indication
   SHIFT IND	CVT Shift selector	P (Park) position	P
   		N (Neutral) position	N

Is the inspection result normal?

YES

Inspection End.

NO

Refer to Component Inspection .