LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Security Control System (DTC/Circuit Diagnosis)) >> DTC / Circuit Diagnosis >> DTC B2195: Anti-Scanning >> Diagnosis Procedure

Diagnosis Procedure

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK SELF DIAGNOSTIC RESULT 1 

    SYMBOL CONSULT

    1. Select "Self Diagnostic Result" mode of "BCM".
    2. Erase DTC.
    3. Perform DTC CONFIRMATION PROCEDURE for DTC B2195. Refer to DTC Description .

    Is DTC detected?

    YES

    GO TO 2.

    NO

    Inspection End.

  2. CHECK EQUIPMENT OF THE VEHICLE 

    Check that unspecified accessory part related to engine start is not installed.

    Is unspecified accessory part related to engine start installed?

    YES

    GO TO 3.

    NO

    GO TO 4.

  3. CHECK SELF DIAGNOSTIC RESULT 2 

    SYMBOL CONSULT

    1. Obtain the customers approval to remove unspecified accessory part related to engine start, and then remove it.
    2. Select "Self Diagnostic Result" mode of "BCM".
    3. Erase DTC.
    4. Perform DTC CONFIRMATION PROCEDURE for DTC B2195. Refer to DTC Description .

    Is DTC detected?

    YES

    GO TO 4.

    NO

    Inspection End.

  4. REPLACE BCM 

    Replace BCM. Refer to Removal and Installation .

    Inspection End.

scientia non olet · About LEMON Manuals