Automatic Drive Positioner (DTC/Circuit Diagnosis)
WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK TELESCOPIC SWITCH SIGNAL
- Disconnect ADP steering switch (telescopic switch).
- Check voltage between ADP steering switch harness connector M41 and ground.
(+)
(-)
Voltage
(Approx.)
ADP steering switch (telescopic switch)
Connector
Terminal
M41
1
Ground
Battery voltage
6
Is the inspection result normal?
YES
GO TO STEP 3 .
NO
GO TO STEP 2 .
- CHECK TELESCOPIC SWITCH CIRCUIT
- Disconnect automatic drive positioner control unit.
- Check continuity between automatic drive positioner control unit harness connector M33 and ADP steering switch harness connector M41.
Automatic drive positioner control unit
ADP steering switch (telescopic switch)
Continuity
Connector
Terminal
Connector
Terminal
M33
7
M41
1
Yes
19
6
- Check continuity between automatic drive positioner control unit harness connector M33 and ground.
Automatic drive positioner control unit
Ground
Continuity
Connector
Terminal
M33
7
No
19
Is the inspection result normal?
YES
Replace automatic drive positioner unit. Refer to Removal and Installation .
NO
Repair or replace harness.
- CHECK TELESCOPIC SWITCH
Refer to Component Inspection .
Is the inspection result normal?
YES
GO TO STEP 4 .
NO
Replace ADP steering switch (telescopic switch). Refer to Removal and Installation .
- CHECK INTERMITTENT INCIDENT
Refer to Intermittent Incident .
Inspection End.