Automatic Drive Positioner (DTC/Circuit Diagnosis)

WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.

CHECK SEAT MEMORY INDICATOR CIRCUIT

Turn ignition switch OFF.
Disconnect driver seat control unit and seat memory switch.

Check continuity between driver seat control unit harness connector B222 and seat memory switch harness connector D10.

Driver seat control unit		Seat memory switch		Continuity
Connector	Terminal	Connector	Terminal
B222	10	D10	13	Yes
	26		14

Check continuity between driver seat control unit harness connector B222 and ground.

Driver seat control unit		Ground	Continuity
Connector	Terminal
B222	10		No
	26

Is the inspection result normal?

YES

GO TO STEP 2

Repair or replace harness.

CHECK MEMORY INDICATOR POWER SUPPLY

Check voltage between seat memory switch harness connector D10 and ground.

(+)		(-)	Voltage (Approx.)
Seat memory switch
Connector	Terminal
D10	15	Ground	Battery voltage

Is the inspection result normal?

YES

GO TO STEP 3

Check the following:

10 A fuse No. 6.
Harness for open or short between memory indicator and fuse.

CHECK MEMORY INDICATOR
Refer to Component Inspection .

Is the inspection result normal?

YES

GO TO STEP 4 .

NO

Replace seat memory switch. Refer to Removal and Installation .
CHECK INTERMITTENT INCIDENT
Refer to Intermittent Incident .

Is the inspection result normal?

YES

Replace driver seat control unit. Refer to Removal and Installation .

NO

Repair or replace the malfunctioning part.