Automatic Drive Positioner (DTC/Circuit Diagnosis)
WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
- SELF DIAGNOSTIC RESULT
CONSULT
- Turn ignition switch ON.
- Check "Self Diagnostic Result" of "AUTO DRIVE POS.".
- Erase the DTC.
- Perform DTC confirmation procedure. Refer to DTC Description .
Is the DTC displayed again?
YES
GO TO STEP 2
NO
Check intermittent incident. Refer to Intermittent Incident .
- CHECK SLIDING MOTOR LH CIRCUIT (POWER SHORT)
- Turn ignition switch OFF.
- Disconnect sliding motor LH and driver seat control unit connector.
- Check voltage between sliding motor LH harness connector and ground.
(+)
(-)
Voltage
(Approx.)
Sliding motor LH
Connector
Terminals
B226
1
Ground
0 V
5
Is the inspection result normal?
YES
GO TO STEP 3 .
NO
Repair or replace harness or connector.
- CHECK DRIVER SEAT CONTROL UNIT OUTPUT SIGNAL
- Connect driver seat control unit connector.
- Check voltage between driver seat control unit harness connector and ground.
(+)
(-)
Voltage
(Approx.)
Driver seat control unit
Connector
Terminals
B223
36
Ground
0 V
44
Is the inspection result normal?
YES
GO TO STEP 4 .
NO
Replace driver seat control unit. Refer to Removal and Installation .
- CHECK INTERMITTENT INCIDENT
Refer to Intermittent Incident .
Inspection End.