Diagnosis Procedure

CONSULT

1. Turn ignition switch ON.
2. Select "DETE/CANCEL SW" and "DETENT SW - IPDM" in "Data Monitor" mode.
3. Check "DETE/CANCEL SW" and "DETENT SW - IPDM" indication under the following conditions:

   Monitor item	Condition		Indication
   DETE/CANCEL SW	A/T Shift selector	In any position other than P (Park)	OFF
   		P (Park)	ON
   DETENT SW - IPDM	A/T Shift selector	In any position other than P (Park)	OFF
   		P (Park)	ON

Is the inspection result normal?

YES

Refer to Intermittent Incident .

NO

If "DETE/CANCEL SW" function is incorrect. GO TO 2.

NO

If "DETENT SW - IPDM" function is incorrect. GO TO 5.

1. Disconnect BCM connector and A/T shift selector (park position switch)connector.
2. Check continuity between A/T shift selector (park position switch) harness connector and BCM harness connector.

   A/T shift selector (park position switch)		BCM		Continuity
   Connector	Terminal	Connector	Terminal
   M68	4	M18	20	Yes

3. Check continuity between A/T shift selector (park position switch) harness connector and ground.

   A/T shift selector (park position switch)		Ground	Continuity
   Connector	Terminal
   M68	4		No

Is the inspection result normal?

YES

GO TO 3 .

NO

Repair or replace harness.

1. Disconnect BCM.
2. Check connectors and terminals for deformation, disconnection, looseness or damage.

Is the inspection result normal?

YES

GO TO 4 .

NO

Repair or replace as necessary.

1. Replace BCM. Refer to Removal and Installation .
2. Perform initialization of BCM and registration of all Intelligent Keys using CONSULT.

Inspection End.

1. Disconnect A/T shift selector (park position switch) connector and IPDM E/R connector.
2. Check continuity between A/T shift selector (park position switch) harness connector and IPDM E/R harness connector.

   A/T shift selector (park position switch)		IPDM E/R		Continuity
   Connector	Terminal	Connector	Terminal
   M68	4	E130	64	Yes

3. Check continuity between A/T shift selector (park position switch) harness connector and ground.

   A/T shift selector (park position switch)		Ground	Continuity
   Connector	Terminal
   M68	4		No

Is the inspection result normal?

YES

GO TO 6 .

NO

Repair or replace harness.

1. Disconnect IPDM E/R.
2. Check connectors and terminals for deformation, disconnection, looseness or damage.

Is the inspection result normal?

YES

GO TO 7 .

NO

Repair or replace as necessary.

1. Replace IPDM E/R. Refer to Removal and Installation of IPDM E/R .

Inspection End.