LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 143 (Power Distribution System) >> Power Distribution System >> DTC/Circuit Diagnosis >> B260A Ignition Relay >> Diagnosis Procedure

Diagnosis Procedure

WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
  1. SELF DIAGNOSTIC RESULT 

    SYMBOL CONSULT

    Perform "Self Diagnostic Result" mode of "IPDM E/R".

    Are any DTCs detected?

    YES

    Refer to DTC Index .

    NO

    GO TO 2 .

  2. CHECK IGNITION RELAY-1 POWER SUPPLY (IPDM E/R) 

    Check voltage between IPDM E/R connector E130 terminal 68 and ground.

    IPDM E/R

    Ground

    Condition

    Voltage

    (Approx.)

    Connector

    Terminal

    E130

    68

    -

    Ignition: OFF

    Battery voltage

    Ignition: ON

    0V

    Is the inspection result normal?

    YES

    Replace IPDM E/R. Refer to Removal and Installation of IPDM E/R .

    NO

    GO TO 3.

  3. CHECK IGNITION RELAY-1 POWER SUPPLY (BCM) 

    Check voltage between BCM connector M19 terminal 70 and ground.

    BCM

    Ground

    Condition

    Voltage

    (Approx.)

    Connector

    Terminal

    M19

    70

    -

    Ignition: OFF

    Battery voltage

    Ignition: ON

    0V

    Is the inspection result normal?

    YES

    Refer to Intermittent Incident .

    NO

    Replace BCM. Refer to Removal and Installation .