LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 142 (Engine Control System (Basic Inspection) (CUMMINS 5.0L)) >> Basic Inspection >> Rotary Turbine Control Valve Actuator Calibration >> Work Procedure

Work Procedure

WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.
  1. PERFORM ROTARY TURBINE CONTROL VALVE ACTUATOR CALIBRATION 

    SYMBOL CONSULT

    1. Turn ignition switch ON.
    2. Select "RTCV actuator calibrate" in "Work support" mode of "ENGINE".
      3. NOTE: The calibrate command must only be performed with the actuator mounted to the engine and attached to the linkage.

    3. Touch "Calibrate".

    4. Follow the instructions on CONSULT display.
      NOTE: It is normal to have DTC P2262-00 at this point.
    5. If CONSULT indicates the procedure was stopped or failed, turn the ignition switch OFF for 70 seconds, then turn the ignition switch ON and repeat steps 3 and 4 up to (5) times.
    6. After (5) consecutive failed attempts, it is necessary to replace the rotary turbine control valve actuator linkage.
    7. Using CONSULT, erase "ENGINE" diagnostic trouble codes.

    GO TO 2.

  2. VERIFY ROTARY TURBINE CONTROL VALVE ACTUATOR CALIBRATION 

    Operate the engine to be sure the turbocharger actuator operates correctly and all turbocharger actuator DTCs are past.

    Inspection End.

scientia non olet · About LEMON Manuals