Work Procedure

WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.

START
NOTE:
- Before performing this procedure, record injector adjustment value printed on a fuel injector.
1. Turn ignition switch ON (engine stopped).
2. Select "ENTER INJECTOR CODES" in "Work support" mode of "ENGINE" using CONSULT.
3. Touch "START".
  NOTE: When touching "START", CONSULT reads injector adjustment values stored in ECM.
4. Select the number of the cylinder which needs Injector Adjustment Value Registration.
5. Input injector adjustment value.
6. Repeat step 4 - 5 until there is no cylinder which needs Injector Adjustment Value Registration, and touch "START".
  NOTE: When touching "START", injector adjustment values stored in CONSULT are written onto ECM memory.
7. Check that the following values are same for each cylinder:
  - Injector adjustment value which is printed on a fuel injector.
  - Injector adjustment value which is displayed on CONSULT screen.
    NOTE:
    In this step, CONSULT reads injector adjustment values stored in ECM and displays the values on the CONSULT screen. This is for checking if injector adjustment values are written onto ECM memory correctly.
    
    If DTC is detected, perform DTC Confirmation Procedure for the DTC, and check if the same DTC is detected again.
8. Turn ignition switch OFF and wait at least 1 minute.
Inspection End.