LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 140 (Engine Control System (Symptom Diagnosis & Removal And Installation) (CUMMINS 5.0L)) >> Removal And Installation >> Glow Control Unit >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery or batteries. Refer to Battery Disconnect .
    WARNING: Battery acid and battery acid fumes are extremely dangerous and can cause severe burns and explosion. To help reduce the risk of personal injury:
    • Wear appropriate goggles and protective clothing.
    • Always properly ventilate the area where the service is being performed.
    • Never allow battery fluid to come in contact with skin, eyes, fabrics or painted surfaces.
    • To avoid arcing, remove the negative (-) battery cable first and attach the negative (-) battery cable last.
    • If acid contacts eyes, skin or clothing, immediately flush with water for 15 minutes and seek medical attention.
  2. Remove air cleaner and air duct assembly. Refer to Removal and Installation .
  3. Disconnect the connectors from the glow plug control unit by pressing the connector latch and pulling outward.
  4. Remove the bolts (A) that secure the glow plug control unit to the vehicle chassis.
    GNSALBIA1784Z-784Courtesy of NISSAN NORTH AMERICA, INC.

    Remove the glow plug control unit.