Removal and Installation: Installation
WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.
- Install the new glow plug control unit to the vehicle chassis.CAUTION:
- Make sure no grease or dirt is between the glow plug control unit and the mounting plate.
- To avoid possible damage to the glow plug controller module, do not over-tighten the mounting capscrews.
- Tighten the bolts (A).
- Use a suitable tool to remove all dirt and moisture from the glow plug control unit connector ports and the harness connectors.
- Connect the harness connectors to glow plug control unit by pushing them into their corresponding connector cavities.NOTE: An audible click should be heard when the connection is made.
- Install the air cleaner and air duct assembly. Refer to Removal and Installation .
- Connect the battery or batteries. Refer to Battery Disconnect
.WARNING: Battery acid and battery acid fumes are extremely dangerous and can cause severe burns and explosion. To help reduce the risk of personal injury;
- Wear appropriate goggles and protective clothing.
- Always properly ventilate the area where the service is being performed.
- Never allow battery fluid to come in contact with skin, eyes, fabrics or painted surfaces.
- To avoid arcing, remove the negative (-) battery cable first and attach the negative (-) battery cable last.
- If acid contacts eyes, skin or clothing, immediately flush with water for 15 minutes and seek medical attention.
- Operate the engine and check for loose components.