LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 139 (Engine Control System (DTCS, Symptom Diagnosis & Removal And Installation) (5.6L) (8 Of 8)) >> DTC/Circuit Diagnosis >> Removal And Installation >> Fuel Pump Control Module (FPCM) >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Additional service must be performed when replacing fuel pump control module. Refer to System Description .
  1. Remove the rear wheel and tire (LH) using power tool. Refer to Removal and Installation .
  2. Remove the rear fender protector (LH). Refer to Removal and Installation - Rear Fender Protector .
  3. Disconnect the harness connector from fuel pump control module.
  4. Remove bolts, and fuel pump control module and bracket assembly from vehicle.
  5. Remove screws, and fuel pump control module from fuel pump control module bracket (if necessary).
scientia non olet · About LEMON Manuals