LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 138 (Automatic Transmission (Introduction, Wiring Diagrams And Basic Inspection) (Re6R01A)) >> Basic Inspection >> Stall Test >> Inspection and Judgment >> Inspection

Inspection and Judgment: Inspection

WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the amount of engine oil. Replenish the engine oil if necessary.
  2. Drive for about 10 minutes to warm up the vehicle so that the A/T fluid temperature is 70 to 80°C (158 to 176°F). Inspect the amount of ATF. Replenish if necessary.
  3. Securely engage the parking brake so that the tires do not turn.
  4. Start the engine, apply foot brake, and place selector lever in D position.
  5. Gradually press down the accelerator pedal while holding down the foot brake.
  6. Quickly read off the stall speed, and quickly release the accelerator pedal.
    CAUTION: Never hold down the accelerator pedal for more than 5 seconds during this test.

    Stall speed

    : Refer to Stall Speed .
  7. Shift the selector lever to N position.
  8. Cool down the ATF.
    CAUTION: Run the engine at idle for at least 1 minute.
  9. Repeat steps 5 through 8 with selector lever in R position.
scientia non olet · About LEMON Manuals