LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 138 (Automatic Transmission (Introduction, Wiring Diagrams And Basic Inspection) (Re6R01A)) >> Basic Inspection >> How To Erase Permanent DTC >> Description

How To Erase Permanent DTC: Description

WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.

Permanent DTC can be erased by driving each driving pattern.

Permanent DTC

Driving cycle

P0613

Perform the following cycles three times:

  1. Start the engine and wait at least 5 seconds.
  2. Stop the engine.

P0705

Perform the following cycles three times:

  1. Start the engine.
  2. Shift the selector lever through entire positions from P to D.
  3. Stop the engine.

P0708

-

P0711
  1. Soak the vehicle at least 8 hours.
  2. Start the engine.
  3. Set the vehicle to idling at least 180 seconds.
  4. Shift the selector lever to D position.
  5. Maintain the following condition at least 7 minutes:
    • Vehicle speed: 41 km/h (25 MPH) or more
  6. Implement the following conditions:
    • ATF temperature at the time of the engine start: 20°C (68°F) or less
    • Selector lever: D
    • Accelerator pedal opening: 10% or more
    • ATF temperature: 25°C (77°F) or more

P0712

Perform the following cycles three times:

  1. Start the engine and wait at least 10 seconds.
  2. Stop the engine.

P0713

Perform the following cycles three times:

  1. Start the engine and wait at least 10 seconds.
  2. Stop the engine.

P0715

Perform the following cycles three times:

  1. Start the engine and wait at least 5 seconds.
  2. Stop the engine.

P0716

Perform the following cycles three times:

  1. Start the engine and wait at least 10 seconds.
  2. Stop the engine.

P0717

Perform the following cycles three times:

  1. Start the engine.
  2. Shift the selector lever to D position.
  3. Maintain the following condition at least 6 seconds:
    • Vehicle speed: 55 km/h (34 MPH) or more
  4. Stop the engine.

P0720

Perform the following cycles three times:

  1. Start the engine.
  2. Shift the selector lever to D position.
  3. Drive the vehicle at least 5 seconds.
  4. Stop the engine.

P0721

Perform the following cycles three times:

  1. Start the engine.
  2. Shift the selector lever to D position.
  3. Drive the vehicle at least 10 seconds.
  4. Stop the engine.

P0722

Perform the following cycles three times:

  1. Start the engine.
  2. Shift the selector lever to D position.
  3. Maintain the following condition at least 6 seconds:
    • Vehicle speed: 55 km/h (34 MPH) or more
  4. Stop the engine.

P0725

Perform the following cycles three times:

  1. Start the engine.
  2. Shift the selector lever to D position.
  3. Maintain the following condition at least 2 seconds:
    • Vehicle speed: 39 km/h (24 MPH) or more
  4. Stop the engine.

P0729

Perform the following cycles three times:

  1. Start the engine.
  2. Set the vehicle to idling at least 10 seconds.
  3. Shift the selector lever to D position.
  4. Drive the vehicle at least 2 seconds in 6GR.
  5. Stop the engine.

P0730

Perform the following cycles three times:

  1. Start the engine and wait at least 5 seconds.
  2. Stop the engine.

P0731

Perform the following cycles three times:

  1. Start the engine.
  2. Set the vehicle to idling at least 10 seconds.
  3. Shift the selector lever to D position at least 2 seconds.
  4. Maintain the following condition at least 2 seconds in 1GR:
    • Vehicle speed: 2 km/h (1 MPH) or more
  5. Stop the engine.

P0732

Perform the following cycles three times:

  1. Start the engine.
  2. Set the vehicle to idling at least 10 seconds.
  3. Shift the selector lever to D position.
  4. Drive the vehicle at least 2 seconds in 2GR.
  5. Stop the engine.

P0733

Perform the following cycles three times:

  1. Start the engine.
  2. Set the vehicle to idling at least 10 seconds.
  3. Shift the selector lever to D position.
  4. Drive the vehicle at least 2 seconds in 3GR.
  5. Stop the engine.

P0734

Perform the following cycles three times:

  1. Start the engine.
  2. Set the vehicle to idling at least 10 seconds.
  3. Shift the selector lever to D position.
  4. Drive the vehicle at least 2 seconds in 4GR.
  5. Stop the engine.

P0735

Perform the following cycles three times:

  1. Start the engine.
  2. Set the vehicle to idling at least 10 seconds.
  3. Shift the selector lever to D position.
  4. Drive the vehicle at least 2 seconds in 5GR.
  5. Stop the engine.

P0736

Perform the following cycles three times:

  1. Start the engine.
  2. Set the vehicle to idling at least 10 seconds.
  3. Shift the selector lever to R position.
  4. Drive the vehicle at least 2 second s.
  5. Stop the engine.

P0743

Perform the following cycles three times:

  1. Start the engine and wait at least 5 seconds.
  2. Stop the engine.

P0748

Perform the following cycles three times:

  1. Start the engine and wait at least 5 seconds.
  2. Stop the engine.

P0752

Perform the following cycles three times:

  1. Start the engine.
  2. Warm A/T fluid.
    • Transmission fluid temperature: 40°C (104°F) or more
  3. Shift the selector lever to D position.
  4. Drive the vehicle and shift the gear from 4th to 5th with the accelerator pedal released.
  5. Stop the engine.

P0753

Perform the following cycles three times:

  1. Start the engine and wait at least 5 seconds.
  2. Stop the engine.

P0758

Perform the following cycles three times:

  1. Start the engine and wait at least 5 seconds.
  2. Stop the engine.

P0763

Perform the following cycles three times:

  1. Start the engine and wait at least 5 seconds.
  2. Stop the engine.

P0768

Perform the following cycles three times:

  1. Start the engine and wait at least 5 seconds.
  2. Stop the engine.

P0770

Perform the following cycles three times:

  1. Start the engine.
  2. Set the vehicle to idling at least 5 seconds.
  3. Shift the selector lever to D position.
  4. Drive the vehicle at least 2 seconds in 2GR.
  5. Stop the engine.

P0773

Perform the following cycles three times:

  1. Start the engine and wait at least 5 seconds.
  2. Stop the engine.

P0826

-

P0863

Perform the following cycles three times:

  1. Start the engine and wait at least 5 seconds.
  2. Stop the engine.

P0882

Perform the following cycles three times:

  1. Start the engine and wait at least 5 seconds.
  2. Stop the engine.

P0998

Perform the following cycles three times:

  1. Start the engine and wait at least 5 seconds.
  2. Stop the engine.

P0999

Perform the following cycles three times:

  1. Start the engine and wait at least 5 seconds.
  2. Stop the engine.

P1679

-

P1705

Perform the following cycles three times:

  1. Start the engine and wait at least 5 seconds.
  2. Stop the engine.

P1721

Perform the following cycles three times:

  1. Start the engine.
  2. Shift the selector lever to D position.
  3. Drive the vehicle at least 2 seconds in creep.
  4. Stop the engine.

P215C

Perform the following cycles three times:

  1. Start the engine.
  2. Shift the selector lever to D position.
  3. Maintain the following condition at least 2 seconds:
    • Vehicle speed: 42 km/h (26 MPH) or more
  4. Release the accelerator pedal at least 1 second.
  5. Stop the engine.

P2637

-

P2741

-

P2742

-

P2743

-

P2757

Perform the following cycles three times:

  1. Start the engine.
  2. Shift the selector lever to D position.
  3. Drive the vehicle at least 3 seconds in 3GR.
  4. Stop the engine.

P279D

Perform the following cycles three times:

  1. Start the engine.
  2. Shift the selector lever to D position.
  3. Maintain the following condition at least 11 seconds:
    • 4WD mode switch: 2WD
    • Vehicle speed: 60 km/h (37 MPH) or more
  4. Maintain the following condition at least 11 seconds:
    • 4WD mode switch: 4WD LOW
    • Vehicle speed: 23 km/h (14 MPH) or more
  5. Stop the engine.

P2803

Perform the following cycles three times:

  1. Start the engine.
  2. Shift the selector lever through entire positions from P to D.
  3. Stop the engine.

U0073

Perform the following cycles three times:

  1. Start the engine and wait at least 5 seconds.
  2. Stop the engine.

U0100

Perform the following cycles three times:

  1. Start the engine and wait at least 5 seconds.
  2. Stop the engine.

U0102

Perform the following cycles three times:

  1. Start the engine and wait at least 5 seconds.
  2. Stop the engine.

U0140

-

U0155

-

U0401

Perform the following cycles three times:

  1. Start the engine and wait at least 5 seconds.
  2. Stop the engine.

U0403

Perform the following cycles three times:

  1. Start the engine and wait at least 5 seconds.
  2. Stop the engine.

U0416

-

U1000

-

U1117

Perform the following cycles three times:

  1. Start the engine and wait at least 5 seconds.
  2. Stop the engine.
scientia non olet · About LEMON Manuals