Rear Power Slide Glass Circuit Inspection
WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK REAR POWER SLIDE GLASS SWITCH OPERATION
- Turn ignition switch OFF.
- Disconnect rear power slide glass switch connector.
- Check continuity between rear power slide glass switch terminals.
Terminals
Condition
Continuity
3
5
Rear power drop glass switch is pressed OPEN
Yes
1
Rear power drop glass switch is pressed CLOSE
Yes
Is the inspection result normal?
YES
GO TO 2 .
NO
Replace rear power slide glass switch. Refer to Removal and Installation .
- CHECK REAR POWER SLIDE GLASS SWITCH GROUND CIRCUIT HARNESS CONTINUITY
Check continuity between rear power slide glass switch connector and ground.
Connector
Terminal
Ground
Continuity
R19
3
Yes
Is the inspection result normal?
YES
GO TO 3 .
NO
Repair or replace harness.
- CHECK REAR POWER SLIDE GLASS SIGNAL
- Connect rear power slide glass switch.
- Disconnect rear power slide glass motor connector.
- Turn ignition switch ON.
- Check voltage between rear power slide glass motor connector and ground.
Connector
(+)
(-)
Condition
Voltage
(Approx.)
B150
1
Ground
Close
Battery voltage
Open
0
2
Close
0
Open
Battery voltage
Is the inspection result normal?
YES
Replace rear power slide glass motor. Refer to Removal and Installation .
NO
Repair or replace harness.