LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 134 (Power Supply, Ground & Circuit Elements) >> Basic Inspection >> Fuse Inspection >> How To Check >> Extended Storage Switch (If Equipped)

Extended Storage Switch (If Equipped)

WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • When extended storage switch is pulled out, a message may be shown in the meter or display. To turn message/display off, push extended storage switch in.
  • The following information is related to extended storage switch (shipping mode). For information related to BCM transit mode, refer to System Description .

The following switch may be mounted on the fuse block (Junction Box) for transportation and storage.

GNSJSMIA0793Z-793Courtesy of NISSAN NORTH AMERICA, INC.

SYMBOL

Extended storage switch

SYMBOL

Type A

SYMBOL

Type B

SYMBOL

Type C

Remove the extended storage switch if it interferes when checking fuses.

How/When to turn Extended Storage Switch ON/OFF 

CAUTION:
  • Turn the ignition switch OFF when operating the extended storage switch.
  • Under normal conditions, keep the extended storage switch in ON state. Never operate the extended storage switch except when necessary.

How To Remove Extended Storage Switch 

Type A

  1. Turn the ignition switch OFF.
  2. Turn the extended storage switch OFF.
  3. Pinch tabs SYMBOL and tilt to disengage the extended storage switch. Pinch tabs SYMBOL to remove the extended storage switch.
    GNSJSMIA0476Z-476Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION: For bus bar type extended storage switch, never replace bus bar with a fuse, or fuse may continually open.
    NOTE:
    • Extended storage switch and fuse (or bus bar) are removed together. Remove fuse (or bus bar) from extended storage switch, if necessary.
    • Install removed fuse (or bus bar) to fuse block.
    • Extended storage switch is for transportation and storage. Reinstallation of switch is not required after removal, but fuse (or bus bar) must be reinstalled/pushed back in to activate all electrical systems and turn message off (which may be shown in meter/display).

Type B

  1. Turn the ignition switch OFF.
  2. Turn the extended storage switch OFF.
  3. Pinch tabs SYMBOL and firmly pull out the extended storage switch in SYMBOL direction.
    GNSJSMIA0477Z-477Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION: For bus bar type extended storage switch, never replace bus bar with a fuse, or fuse may continually open.
    NOTE:
    • Extended storage switch and fuse (or bus bar) may be removed together. Remove fuse (or bus bar) from extended storage switch, if necessary.
    • Install removed fuse (or bus bar) to fuse block.
    • Extended storage switch is for transportation and storage. Reinstallation of switch is not required after removal, but fuse (or bus bar) must be reinstalled/pushed back in to activate all electrical systems and turn message off (which may be shown in meter/display).

Type C

  1. Turn the ignition switch OFF.
  2. Turn the extended storage switch OFF.
  3. Pinch tabs SYMBOL and firmly pull out the extended storage switch in SYMBOL direction.
    GNSJSMIA0795Z-795Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION: For bus bar type extended storage switch, never replace bus bar with a fuse, or fuse may continually open.
    NOTE:
    • Extended storage switch and fuse (or bus bar) are removed together. Remove fuse (or bus bar) from extended storage switch, if necessary.
    • Install removed fuse (or bus bar) to fuse block.
    • Extended storage switch is for transportation and storage. Reinstallation of switch is not required after removal, but fuse (or bus bar) must be reinstalled/pushed back in to activate all electrical systems and turn message off (which may be shown in meter/display).
scientia non olet · About LEMON Manuals