Removal and Installation: Removal

WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Do not damage the door glass or door panel.

Remove the front door finisher. Refer to Removal and Installation .
Remove door inside seal.
Disconnect harness connector from front door speaker.
Remove door vapor barrier.

Courtesy of NISSAN NORTH AMERICA, INC.

CAUTION: Use care not to damage or tear vapor barrier during removal.
Temporarily reconnect the main power window and door lock/unlock switch (LH door) or power window door lock/unlock switch (RH door).
Raise and lower door glass until the door glass regulator to door glass bolts can be seen.
Remove door glass regulator to door glass bolts (A).

Courtesy of NISSAN NORTH AMERICA, INC.
While holding the door glass, raise it at the rear end and pull the door glass out of the sash toward the inside of the door.

Courtesy of NISSAN NORTH AMERICA, INC.
Remove door glass rubber run (if necessary).
Remove door glass front run (if necessary).