Blind Spot Warning System Operation Description
WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
- ADAS control unit enables BSW system.
- The ADAS control unit turns ON the BSW system when selected in driver assistance settings of the combination meter information display.
- Side radar detects a vehicle in the adjacent lane, and transmits the vehicle detection signal to ADAS control unit via ITS communication.
- ADAS control unit starts the control as follows, based on a vehicle detection signal, turn signal and dimmer signal transmitted from BCM via CAN communication:
- Blind Spot Warning indicator signal and Blind Spot Warning indicator dimmer signal transmission to side radar.
- Side radar transmits an indicator operation signal to the Blind Spot Warning indicator on the side the adjacent vehicle is detected.
OPERATING CONDITION
- Blind Spot Warning system display (white): ON
- Vehicle speed: Approximately 20 MPH (32 km/h) or more.NOTE:
- After the operating conditions of warning are satisfied, the warning continues until the vehicle speed reaches approximately 18 MPH (29 km/h)
- The Blind Spot Warning system may not function properly, depending on the situation. Refer to Blind Spot Warning/Rear Cross Traffic Alert (RCTA) System Service .