Work Procedure

WARNING: This page is about a different car, the 2018 Nissan Titan XD and 2018 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Be careful of traffic conditions and safety around the vehicle when performing road test.

CAUTION: Fully understand the following items well before the road test;

Precautions: Refer to Blind Spot Warning/Rear Cross Traffic Alert (RCTA) System Service .
System description for Blind Spot Warning: Refer to System Description .
Normal operating condition: Refer to Description .

CHECK BSW SYSTEM SETTING
1. Start the engine.
2. Check that the BSW system setting can be enabled/disabled on the integral switch.
3. Turn OFF the ignition switch and wait for 5 seconds or more.
4. Check that the previous setting is saved when the engine starts again.
GO TO 2 .

BSW SYSTEM ACTION TEST

Enable the setting of the BSW system on the integral switch.

Check BSW operation according to the following table:

Vehicle condition/ Driver's operation			Action
Vehicle speed (Approx.)	Turn signal condition	Status of vehicle detection within detection area	Indication on the Blind Spot Warning indicator	Indication on the combination meter	Indicator color	Buzzer
Less than approx. 18 MPH (29 km/h)	-	-	OFF	ON	White	OFF
Approx. 20 MPH (32 km/h) or more	-	Vehicle is absent	OFF	ON	White	OFF
	OFF	Vehicle is detected	ON	ON	White	OFF
	ON (vehicle detected direction)	Before turn signal operates Vehicle is detected	Blink	Blink	Yellow (Blink)	Short continuous beeps
	ON (vehicle detected direction)	Vehicle is detected after turn signal operates	Blink	Blink	Yellow (Blink)	OFF

Inspection End.