Inspection After Removal
WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
- When using compressed air for cleaning, to avoid the risk of personal injury from flying debris and dirt:
- Do not exceed 207 kPa (2.111 kg/cm 2 , 30 psi).
- Wear appropriate eye protection and protective clothing including gloves.
- When using high-pressure water or steam cleaning equipment, to avoid the risk of personal injury from flying debris and hot steam:
- Wear appropriate eye protection and protective clothing including gloves and a face shield.
CAUTION:
The use of air or power tools, such as a high speed sander with an abrasive pad, to clean the gasket material can overheat the oil pan and cause damage to the sealing flange.
- Clean gasket residue from the block stiffener plate and oil pan mating surfaces. Do not use abrasive pads or steel scrapers.
- Use solvent to clean the oil pan.
- Dry the oil pan with compressed air.
- Clean the surface of the block stiffener plate of any remaining oil and contaminants.
- Inspect the bottom of the oil pan for debris. If debris is present, perform an oil filter analysis.
- Inspect the oil pan for cracks, scratches, and other damage. If damage is found, replace the oil pan.
- Inspect the oil suction tube and tube braces for damage. If damage is found, replace the oil suction tube.
- Inspect the oil drain plug threads and the sealing surface for damage.
- If damage is present, replace the oil drain plug.