LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 126 (Engine Mechanical (CUMMINS 5.0L) (1 Of 2)) >> Removal And Installation >> Engine Coolant Temperature Sensor >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery or batteries. Refer to Battery Disconnect .
    WARNING: Battery acid and battery acid fumes are extremely dangerous and can cause severe burns and explosion. To help reduce the risk of personal injury:
    • Wear appropriate goggles and protective clothing.
    • Always properly ventilate the area where the service is being performed.
    • Never allow battery fluid to come in contact with skin, eyes, fabrics, or painted surfaces.
    • To avoid arcing, remove the negative (-) battery cable first and attach the negative (-) battery cable last.
    • If acid contacts eyes, skin or clothing, immediately flush with water for 15 minutes and seek medical attention.
  2. Drain the coolant. Refer to Changing Engine Coolant .
    WARNING:
    • To avoid the risk of personal injury, do not remove the radiator cap when the engine is hot. Serious burns could occur from high-pressure engine coolant escaping from the radiator. Wrap a thick cloth around the cap. Slowly turn it a quarter of a turn to release built-up pressure. Carefully remove the radiator cap by turning it all the way.
    • Coolant is toxic and can be fatal if swallowed. Keep away from pets and children. If not reused, dispose of in accordance with local environmental regulations.
  3. Clean the area around the coolant temperature sensor.
  4. Disconnect the engine coolant temperature sensor harness connector (A) and remove the engine coolant temperature sensor (1).
    GNSALBIA1807Z-807Courtesy of NISSAN NORTH AMERICA, INC.