Inspection After Removal

WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.

Inspect the engine harness connector and the engine charge-air cooler outlet pressure/temperature sensor for the following:
- Cracked or broken connector shell
- Missing or damaged connector seals
- Dirt, debris, or moisture in or on the connector pins
- Corroded, bent, broken, pushed back, or expanded pins
- Chipped, cracked, extruded, or damaged sensor.
Repair or replace parts as necessary.

Inspect the tip of the sensor for soot and carbon buildup.
WARNING:
When using compressed air for cleaning, to avoid the risk of personal injury from flying debris and dirt:
- Do not exceed 207 kPa (2.111 kg/cm ² , 30 psi).
- Wear appropriate eye protection and protective clothing including gloves.
Use compressed air to remove the soot from the sensor, if necessary.
Do not replace the sensor for soot in the sensor.