LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 126 (Engine Mechanical (CUMMINS 5.0L) (1 Of 2)) >> Removal And Installation >> EGR Bypass Valve >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the intake manifold. Refer to Removal and Installation .
  2. Remove bolts (A) and remove the cover plate (1) from the intake manifold.
    GNSALBIA1967Z-967Courtesy of NISSAN NORTH AMERICA, INC.
  3. Remove the EGR bracket bolts (A), and the EGR cooler assembly (1) from the intake manifold.
    GNSAWBIA2860Z-860Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION: Do not reuse the O-rings.
  4. Remove the bolts (A) and then remove the air intake connection (2) from the intake manifold (1).
    GNSALBIA1976Z-976Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION: Do not reuse the gasket.
  5. Remove the coolant tube [2 (if necessary)].
    GNSALBIA1974Z-974Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION: Do not reuse the O-rings (1).
  6. Remove the bolts (A) and (B) connecting the EGR bypass tube (1) to the EGR bypass valve after removing the air intake connection.
    GNSALBIA1973Z-973Courtesy of NISSAN NORTH AMERICA, INC.
  7. Remove the EGR bypass valve (3).
    GNSALBIA1989Z-989Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION: Do not reuse the gasket (4) or O-rings (1) and (2).

    (5)

    : EGR bypass tube
scientia non olet · About LEMON Manuals