LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 126 (Engine Mechanical (CUMMINS 5.0L) (1 Of 2)) >> Removal And Installation >> EGR Bypass Valve >> Removal and Installation >> Installation

Removal and Installation: Installation

WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate the O-rings with a suitable water-based lubricant and install the coolant tube into the intake manifold.
    CAUTION: Do not reuse the O-rings.
  2. Install the EGR bypass valve (3).
    GNSALBIA1989Z-989Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION: Do not reuse the O-rings (1) and (2) and gasket (4).

    (5)

    : EGR bypass tube
  3. Install bolt (B) first and then install bolts (A).
    GNSALBIA1973Z-973Courtesy of NISSAN NORTH AMERICA, INC.
    NOTE: The EGR bypass tube (1) is slotted for this hole to allow for installation of the bolt (B).
  4. Tighten the bolts in the sequence shown to the specified torque.
    GNSALBIA2136Z-136Courtesy of NISSAN NORTH AMERICA, INC.

    EGR bypass valve bolts

    : 18 N.m (1.8 kg-m, 13 ft-lb)
  5. Installation of remaining components is in the reverse order of removal.
    NOTE: Operate the engine and check for leaks.
scientia non olet · About LEMON Manuals