LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 126 (Engine Mechanical (CUMMINS 5.0L) (1 Of 2)) >> Removal And Installation >> Crankshaft Position Sensor >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2018 Nissan Titan XD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery or batteries. Refer to Battery Disconnect .
    WARNING: Battery acid and battery acid fumes are extremely dangerous and can cause severe burns and explosion. To help reduce the risk of personal injury;
    • Wear appropriate goggles and protective clothing.
    • Always properly ventilate the area where the service is being performed.
    • Never allow battery fluid to come in contact with skin, eyes, fabrics or painted surfaces.
    • To avoid arcing, remove the negative (-) battery cable first and attach the negative (-) battery cable last.
    • If acid contacts eyes, skin or clothing, immediately flush with water for 15 minutes and seek medical attention.
  2. Remove engine under cover. Refer to Removal and Installation .
  3. Disconnect the harness connector from the crankshaft position sensor (1).
    GNSAWBIA0127Z-127Courtesy of NISSAN NORTH AMERICA, INC.
  4. Remove bolt (A) and crankshaft position sensor (1).